| |
| |
Viewing products in Gasoline |
| |
| |
|
|
This allows an additional nozzle to be mounted in any of our Boost Cooler™ kits. It includes a Tee junction piece with our quick-connect fittings, a nozzle holder and a section of hose. Note – injector nozzle is not included. Mounting additional nozzles is required when you need a quantity greater than one nozzle can provide, or if you have a dual plenum/throttle body/carburetor setup to get even distribution. |
 |
|
| |
| |
|
|
Unique design provides the best atomization possible. Nozzles have integrated 100 micron filters. Available in 60 ml/min, 100 ml/min, 175 ml/min, 225 ml/min, 375 ml/min, and 625 ml/min. Support 150-1500 HP.
|
|
|
|
| |
| |
|
|
Low level indicator – now in every Boost Cooler®!
In keeping with the most complete system available, Snow Performance now includes a free low level indicator in each system ($40 value). The indicator switch upgrade includes an LED and an EZ installation grommet for use with any Boost Cooler® reservoir.
|
|
|
|
| |
| |
|
|
The new 2.5 Gallon Reservoir gives much more range than the included 3 qt tanks, and is fairly small in size – 13”l x 9.5”h x 7.5”w (similar to a very small car battery) and includes an additional 10 feet of tubing. |
|
|
|
| |
| |
|
|
Nitro Booster™ is a great power adder designed for use with gasoline engines using Boost Cooler™ water-methanol injection kits. A proprietary blend of nitro methane and a specially developed emulsifier that keeps Nitro Booster™ equally distributed in the water-methanol mixture. This allows for a small percentage of nitro methane to be injected into the engine in the correct proportion with air and fuel to produce impressive increases in power. Usually, around 30 to 50hp increase can be measured. Nitro methane has fewer BTUs than gasoline, but contains oxygen and acts like a chemical supercharger and an octane enhancer to safely increase power. |
|
|
|
| |
| |
|
|
1" thick adatper plate allows a very clean and easy installation of our injector nozzles (one or two) on carbureted applications using a Holley 4500 (Dominator) carburetor or carburetors.
|
|
|
|
| |
| |
|
|
1" thick adatper plate allows a very clean and easy installation of our injector nozzles (one or two) on carbureted applications using square-bore Holley, Edelbrock, or Carter 4 barrel carburetors. |
|
|
|
| |
| |
|
|
Weldable threaded bungs make installing your injector nozzle easier when using thin-walled intake tubing. |
|
|
|
| |
| |
|
|
Need a way to mount your injector nozzle into your silicone or rubber intake tube? Snow Performance now offers a Nozzle Mounting Adapter for those without metal intake tubes. |
|
|
|
| |
|
|
