Home > Gas Water-Methanol Injection Kits > Stage 1 Boost Cooler® (Water-Methanol Injection Kit For Forced Induction Gasoline Engines) >

Stage 1 Boost Cooler™ Forced Induction Water-Methanol Injection Kit
Snow Performance Stage 1 Boost Cooler Water-Methanol Injection Kit


 
Alternative Views:


Free Shipping On Complete Systems!
Our Price $359.99


Product SKU: 201


Add Reservoir Upgrade:
  

Line Options:
  

Quantity:  
Overview Why Snow Performance / Test Reports / Reviews Product Details / Install Instructions / Diagrams
 

Overview


Race gas quality fuel on pump gas! Increase your pump gas octane by 25 points and make more power efficiently with a cooler running motor! The Snow Performance Stage 1 Boost Cooler® water-methanol injection kit is available for all forced induction applications (supercharged/turbocharged) and uses a adjustable boost switch to inject a fixed amount of water-methanol into the system until boost goes below the switch set point. Proven to deliver 30-70 HP increases to all forced induction applications! This makes it a good choice for low to medium boost setups (1-15 PSI) looking for an octane enhancement and cooler intake charge. Activation can also be set up through any other user-chosen switch, such as a full throttle switch, nitrous switch, etc.


Benefits:
  • Cooler Denser Air Charge
  • Achieve 116 Octane Quality Fuel From Pump Gas
  • Safely Run More Boost & Timing
  • Cleans Engine Combustion Of Carbon Build Up
  • Reduce Air Temperatures Greater and More Consistent Than Air to Air Intercooler
Features:
  • Made in USA
  • Nickel Plated 100% Methanol Resistant Metal Fittings
  • Industry Leading 300 PSI Pump For More Pressure Than The Competition
  • Adjustable Boost Setting
  • Level Sensor Upgrade and Red LED to Alert User of Low Level
  • Green LED to Alert User When System is Injecting
  • Your Choice of Red or Black Methanol Resistant High Temp Nylon Tubing
  • 2 Proprietary Hypersonic Nozzles For The Best Atomization on the Market
Whats In The Box:
  • 300 PSI UHO (Ultra High Output) Pump
  • 3 Quart Reservoir
  • All Tubing Necessary for Installation
    • 20' ¼ Inch High Temp Nylon Tubing
    • 18" High Pressure Boost Line
  • Adjustable Boost Switch (1-15 PSI)
  • Pig Tail Harness
  • Level Sensor Upgrade
  • High Flow Check Valve
  • 2 Hyper-Sonic Nozzles
  • Required Hardware Needed For Installation
  • Snow Performance Running S Decal
  • Comprehensive Instructions to Install on Any Forced Induction Vehicle
  • Snow Performance 1-Year Warranty

Average Rating: 5 of 5 Total Reviews: 1 Write a review »

  2 of 2 people found the following review helpful:
 
2005 Mustang GT Procharged December 17, 2015
Reviewer: Adam  
This thing is the bomb! Increased boost to 15 PSI and dropped my air charge from 180 degrees to 120 degrees on the dyno after doing two pulls!

I was not sure wither to go with the Stage 2 or 1 but for reducing IATs this thing works great!

Was this review helpful to you?